Glass Canada

News
IGMA: June 2012

Cross-border harmony


June 25, 2012
By Bill Lingnell

Insulating glass standards have been developed over the years to assist
insulating glass manufacturers, testing laboratories and certifying
agencies in providing quality products and developing insulating glass
units that will have long-term performance for the end user.

Insulating glass standards have been developed over the years to assist insulating glass manufacturers, testing laboratories and certifying agencies in providing quality products and developing insulating glass units that will have long-term performance for the end user. The standards used in North America have been updated recently in the ASTM E 06 committee to accommodate some changes and additions to the newer standards, ASTM E 2188, 2189 and 2190, which have been commonly referred to as the HIGS standards (standing for Harmonization of Insulating Glass Standards). These three standards were a culmination of over six years of work to harmonize the former ASTM E 773, E 774 and E 1887 standards with the Canadian CGSB 12.8 standard. The three newer ASTM standards came into being in 2002. The previous E 773, E 774 and E 1887 standards have been discontinued as ASTM standards.

Currently, the laboratories testing insulating glass in the United States and Canada have the capabilities to test to the criteria referenced in the newer standards. The three ASTM
standards are:

Advertisment
  • ASTM E 2188-10 Standard Test Method for Insulating Glass Unit Performance
  • ASTM E 2189-10 Standard Test Method for Testing Resistance to Fogging in Insulating Glass Units
  • ASTM E 2190-10 Standard Specification for Insulating Glass Unit Performance and Evaluation

The standard specification E 2190 has recently added the testing protocol for argon-gas filled units. In it, argon concentration is measured by either ASTM Test Method E 2649 Test Method for Determining Argon Concentration in Sealed Insulating Units Using Spark Emission Spectroscopy or ASTM Test Method E 2269 Test Method for Determining Argon Concentration in Sealed Insulating Glass Units Using Gas Chromatography.

harmonized_glass

View Larger Chart

The E 2190 also outlines the qualifications for testing triple-glazed units. These have been added to the standard to accommodate the advancing use of triple-glazing in IGUs.

The Canadian standard CAN/CGSB-12.8-97 Insulating Glass Units is used in Canada for units that still require testing to this standard. It is basically used only in Canada and was last revised in 1997 to address argon gas filling of IGUs.

The ASTM standards are being updated and reviewed continuously at the semi-annual meetings of the ASTM E 06 Performance of Buildings committee that take place each April and October. The CGSB has not been active since 1997 relating to the Insulating Glass Standard.

The following chart is a brief comparison of the previously used standards to the presently used standards with regard to the high humidity tests, accelerated weathering tests, volatile fog testing, specimen requirements, and evaluation criterion.


Bill Lingnell has over 46 years of experience in the technical field
of glass and architectural products. He holds three Masters of Science
degrees in engineering: civil, mechanical and engineering science.
Lingnell is the technical consultant for the Insulating Glass
Manufacturers Alliance.


Print this page

Related



Leave a Reply

Your email address will not be published. Required fields are marked *

*